DRILL DRIVER OPERATION (cont.)
13
Wood Drilling
Mark the place where you want to drill with a punch or a nail.
To avoid splintering on breakthrough, either clamp a piece of scrap wood to the
back of your workpiece or continue the hole from the back of the wood when
the drill bit first breaks through.
LED Lights
The drill has 1 LED light (5) built into the unit.
The LED light is located above the variable speed
switch (Fig. 9).
The LED light (5) turns on automatically when you
depress the variable speed trigger (6).
The LED light (5) illuminates dark areas in tight
corners to assist with drilling and screw driving.
This helps achieve a more accurate result in your
workpiece.
When not in use, the drill should be stored in a dry, frost free location, keep out
of children’s reach.
Keep ventilation slots of the drill clean at all times and prevent any from entering.
If the housing of the drill requires cleaning, do not use solvents but cloth only.
Blow out the ventilation slots with compressed air periodically .
Note:
Ozito Industries will not be responsible for any damage or injuries caused by
repair of the biscuit joiner by an unauthorised person or by mishandling.
Limited spare parts are available subject to availability. Please contact your local
Bunnings Special Orders Desk to order the required spare parts.
Most common spare parts listed below
Spare Part Part No.
14.4V Battery Pack SPCDR014-41
Charging Cradle SPCDR014-42
Charging Adaptor SPCDR014-43
1.
2.
1.
2.
3.
1.
2.
3.
4.
Fig. 9
MAINTENANCE
SPARE PARTS
To Next Page
Loading...