Ozito DBS-095 - Operation and Controls; Turning the Tool On and Off; Grinding Stone Adjustment Dial Operation; Drill Bit Sharpening Procedure

2. CONTROLS 3. SHARPENING PROCEDURE
1. To turn on, press the on/
o󰀨switchintothe“I”
position.
Turn the grinding stone
adjustment dial anti-clockwise
to lower the grinding stone.
2. Toturno󰀨,presstheon/
o󰀨switchintothe“O”
position.
Turn the grinding stone
adjustment dial clockwise to
raise the grinding stone.
OPERATION
Turning on/o󰀨
Grinding Stone Adjustment Dial
1. Ensure the drill bit that
requires sharpening is
in the smallest template
guideitts.
2. Turn the drill bit sharpener
on.
3. Press down slightly
on the drill bit while
rotating the bit back
and forth between your
ngers.
4. Turn the drill bit sharpener
o󰀨,removethedrillbitand
examine the cutting edge
is sharp.
5. Rotate the drill bit 180º
and reinsert into the drill
bit sharpener.
180°
6. Repeat steps 2-5. Ensure that both sides of the drill bit are
sharpened for the same amount of time, using the same
amount of pressure.