Ozito PXSGS-5021 - Nail;Staple Selection; Fastener Compatibility; Loading the Cartridge; Staple Loading Procedure

2. NAIL/STAPLE SELECTION 3. LOADING THE CARTRIDGE
Fastener Selection
Accessories to suit this staple gun can be purchased from Bunnings
Warehouse.
This tool accepts staples with the measurements below:
Loading Staples
This staple gun only accepts 8-14mm T50 or JT21 staples. Other types of
staples, including paper staples, will jam the unit. For best results, load a
full row of staples before use.
1. Press the cartridge latch down
and pull the magazine slider out
of the tool.
3. Insert a row of staples into the
magazine.
4. Push the magazine slider back
into the unit until it clips into
place.
a.
b.
8-14MM
JT21 STAPLES
8-14MM
T50 STAPLES
8mm
14mm
10mm
12mm
11.3mm
0.76mm
8mm
14mm
10mm
12mm
11.3mm
1.25mm
0.55mm
8-14MM
JT21 STAPLES
8-14MM
T50 STAPLES
8mm
14mm
10mm
12mm
11.3mm
0.76mm
8mm
14mm
10mm
12mm
11.3mm 1.25mm
0.55mm
WARNING! ENSURE THE TOOL IS SWITCHED
OFF AND THE BATTERY IS REMOVED BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.