Why is the pattern very light and splotchy with my Ozito SGP-300?
A light and splotchy pattern often results from moving the spray gun too fast. Try decreasing the spray regulator dial or decreasing your movement speed.
What to do if Ozito SGP-300 Paint Sprayer pattern runs or sags?
If the pattern runs or sags, it's likely because you're applying too much material. Try decreasing the spray regulator dial or increasing your movement speed.
Why is there too much overspray from my Ozito Paint Sprayer?
Too much overspray can occur if the gun is too far from the spray object; reduce the distance. It can also happen if too much material is being applied, so decrease the spray regulator dial.
What to do if Ozito SGP-300 Paint Sprayer spray jet pulsates?
If the spray jet pulsates, it could be because the material in the paint pot is running out; refill it. Alternatively, the air filter might be clogged, so clean or replace it.
Why is my Ozito Paint Sprayer material leaking?
If your paint sprayer is leaking material, check if the nozzle is loose and tighten it. The nozzle might also be worn and need replacement. Another cause could be material build-up on the air cap and nozzle, so clean them thoroughly.
What to do if my Ozito Paint Sprayer atomization is too coarse?
If the atomization is too coarse, it might be due to several factors. The viscosity of the material may be too high, so thin it out. The material volume could be too large; decrease the spray regulator dial. Check if the nozzle or air filter is clogged and clean or replace them. Also, ensure there's enough pressure build-up in the container by tightening the paint pot.
Why is there little or no material flow from my Ozito Paint Sprayer?
There could be several reasons for this. The nozzle or suction tube might be clogged, so try cleaning them. The spray regulator dial may be set too low; increase it. The suction tube could be loose; ensure it's properly inserted. Check if there's no pressure build-up in the paint pot and tighten it if necessary. Lastly, the air filter might be clogged, so clean or replace it.
General| Brand | Ozito |
|---|---|
| Model | SGP-300 |
| Category | Paint Sprayer |
| Language | English |
Instructions on adjusting the suction tube for different spraying orientations.
Best practices for surface preparation and spraying motion for uniform finish.
Step-by-step guide for thorough cleaning of the spray gun after each use.
To Next Page
