12
If using a Saucisse pack go to Step 8
Step 5. Once the LE and rear of the
wing has been sorted, turn the whole
wing on its side.
Step 6. Use your hand to feel the
ends of the longest plastics then fold
the LE from this point.
Step 7. Now place the wing, folded
edge first into the stuff sack before
folding the trailing
edge inside.
Step 8. If using the Saucisse Pack
carefully do it up without trapping any
material.
Step 9. Turn the Saucisse on its side
and make the first fold just after the LE
reinforcements. Do not fold the plastic
reinforcements, use 3 folds around the
LE.
IMPORTANT: Do NOT lay the wing at on the ground before
packing the glider, this will cause abrasion damage to the top
surface as you pull the glider towards the middle. ALWAYS pack
from a mushroom or lift the wing off the ground when gathering
the wing and grouping the leading edge.
Important: Do not fold the glider in the centre, you will
bend the plastics, instead pack the wing with a full concer-
tina method from tip to tip before packing into the stuff sac.
To Next Page
Loading...
