SUPPLY BY THE MANUFACTURER
The following Standard items are supplier to the Installer with each Our Solar Hot Water System
1. Storage tank
2. Flat plate solar collector (s)
3. Roof mounting system for Standard pitched roof installations
4. Roof mounting brass fittings kit including temperature well and air valve
5. Flow restrictor to suit either 1 collector or 2 collector system
6. Booster heating element Either 2.4 kw (250,300 litre tank) or 3.6kw (400 litre tank)
7. Thermostat
8. Thermostat mounting bracket
9. System controller
10. Circulation Pump
11. Housing for system controller and pump assembly
12. Pressure / Temperature Relief ( P / T ) valve
13. Additional valves may be provided by the manufacturer – Specific to client
14. Polyslab base.
SUPPLY BY THE INSTALLER
The following items are to be supplied by the installer
1. All labour required to fully install, test and commission the system
2. Copper piping ( DN15 ) to complete the installation
3. Thermal UV resistant insulation for all copper piping 13mm
4. Brass fittings including joiners, copper olives, elbows etc to complete the installation
5. Any additional valves or fittings required under local regulations
6. Electrical conduit, wiring, labels, sealants, screws and washers
7. Any other non Standard items required to complete the installation
NOTE: ALL VALVES SUPPLIED MUST BE INSTALLED
1
To Next Page
Loading...