5
OZtent RV Owner’s Manual
1.
2.
Install your 2.2m Awning Poles. Lock them at the
height of your tent roof at rst.
Assemble your ridge pole. Twist to lock at desired
location.
SETTING UP YOUR OZTENT FLY
1.
Throw your Oztent Fly over the erected tent. Tilt it
forward and zip the Oztent Fly on the top of the tent.
2.
Place the 1.7m poles on each side to create
spacing and secure with guy ropes as shown.
SETTING UP YOUR PEAK SIDE PANELS
1.9m
2.2m
SETTING UP YOUR PEAK SIDE PANELS
3. 4.
Zip on the Peak Side Panels. Panels are marked A
and B. Match against the A,B markings on the tent.
Fully extend the 2.2m Awning Poles when the
Peaked Side Panel is zipped on half way.
5.
6.
Zip on the rest of the Peaked Side Panel. Secure
the velcro tabs to the poles.
Repeat for the second panel and then extend the
2.2m poles. Secure the poles with the guy ropes.
SETTING UP YOUR PEAK SIDE PANELS
Note: For easy set-up, lower down the 1.9m poles
before zip on the panels.
To Next Page
Loading...
