P.A.P. Heating Solutions HA308N User Manual

Heating Solutions
P.A.P. Heating Solutions Pty Ltd
23 Winchcombe Court
MITCHELL ACT 2911
Ph: 02 6242 9310
www.papheatingsolutions.com.au
HA308N and HA308S1
PROGRAMMABLE OR MANUAL THERMOSTAT
 Programmable Settings: Manual / Timing On/Off / 5+2 Day Programmable
SPECIFICATIONS
 Sensing element : NTC
 Display: LCD
 Power consumption:<2W
 Set-point range: Room Temp: 5 ℃ to 35 ℃ (N)
Floor Temp: 5 ℃ to 90 ℃ (S1)
 Accuracy: ± 1 ℃
 Button: Touch pad
 Switch current rating: < 16A (resistive load)
< 6A (inductive load)
 Power supply: AC85 ～ 260V, 50/60 Hz
 Dimensions: 86 × 86 × 13 mm (W × H × D)
 Fixing screw width: 60mm
 Housing: ABS + PC Flame Retardant
 Operating rating: 0 ～ 40 ℃ , 5 ～ 95%RH (non-
condensing)
 TUV CE Certification
BUTTON DESCRIPTION
HA308N-Room or Air Temperature
HA308S1-Floor Temperature
Day of the Week
Heating On
On/Off
Mode
Clock
Down
Up
WIRING DIAGRAMS
HA308N
HA308S1
L-Line In
N-Neutral In
L-Load Active-16amp, 3800w
N-Load Neutral
L-Line In
N-Neutral In
L-Load Active-16amp, 3800w
N-Load Neutral
Remote Floor
Sensor
MOUNTING
1. Open the main con-
trol panel: put a
3.5mm screwdriver
into the opening
slots, at either side of
the base. Prise up,
opening the clips.
2. Fix the backing
plate to the wall
mounting bracket
3. Connect wiring to
the terminals, as per
the wiring diagram -
refer drawing above
4. Fit the connected
thermostat onto the
backing plate, then fix
it with the two sup-
plied screws
5. Sit the cover at a 30
degree angle then
push down into place,
ensuring the two clips
at the bottom are se-
cure

P.A.P. Heating Solutions HA308N Specifications

General

Display	LCD
Category	Thermostat
Power Supply	24 VAC
Temperature Range	5°C to 30°C
Accuracy	±0.5°C
Installation	Wall Mount

Summary

Product Overview and Specifications

Product Identification

Identifies the HA308N and HA308S1 as programmable or manual thermostats.

Key Specifications

Details sensing element, display, power, temperature range, accuracy, and electrical ratings.

User Interface and Operation

Button and Display Descriptions

Explains button functions and display indicators for HA308N and HA308S1 models.

Operating Instructions

Guides on powering on/off, setting clock, thermostat modes, and manual temperature selection.

Setting Heating Programs

Details how to program temperature settings for weekdays and weekends.

Symbol Meanings and Calibration

Explains RT/SET symbols and provides instructions for temperature calibration.

Installation Guide

Mounting Procedure

Step-by-step instructions for opening the panel, fixing the backing plate, and attaching the thermostat.

Wiring Diagrams

Provides wiring schematics for HA308N and HA308S1 models, including floor sensor connection.