P.L.A. Plasy - Aeration; Sliding windows

Operating and maintenance manual – ENGLISH
22
Aeration
Oxygen inside the motorhome decreases signicantly depending on the passengers, on the lighted
cooker and on the use of heating. The air inside must be therefore constantly renewed.
The percentage increase of carbon dioxide (CO2)constitutes a serious risk of asphyxia.
The openings (circle windows’ sides, sockets, load openings, doors etc) can allow the entrance of
cold air.
In climatic condition with particularly high dampness condensation can form on the metal objects,
despite the sufcient aeration degree inside the motorhome.
In outside temperature particularly cold, condensation can form inside the double acrylic glasses; it is
a phenomenon scheduled in the production phase of the slabs, that are able to drain the condensation
in case of temperature increase. Do not fear therefore damages caused by condensation formation.
Take care of creating a continuous air change above all in case the external temperature is particularly
cold, in order to avoid condensation. You will obtain a comfortable climate inside the motorhome
dosing in the right measure the air change with relation to the power of the heating system. In summer,
if the outside temperature is particularly high, the warm air stagnates inside; aerate the vehicle opening
widely the doors and the windows at regular intervals.
In conformity with the in force dispositions about security, your vehicle has got xed openings, not
obstructable, for a constant air owing inside the motorhome, which is fundamental for your wellness.
The continuous ventilation openings are located in some of the not obstructable circle windows on the
roof(Pict.12) and where expected, in the space of the entrance step(Pict. 11).
In march, in particular for the passengers seated in the back dinettes, it is possible to perceive the
presence of airows. This phenomenon is due to the presence of the not obstructable aeration opening
scheduled by the rules and not ascribable to manufactory defects or assemblage shortcomings.
Pict. 11 Pict. 12
Sliding windows
To open:
Press the buttons of the central blocking mechanism.
Let the half part of the glass, which is to be opened, run over.
To close:
Let the glass run over in closing position.
Activate the blocking device. Always check that the sliding doors are blocked before leaving the
motorhome unattended.