P.Lindberg Extremig 130

Questions and Answers

R
Robert SmithAug 9, 2025
Why is the welding arc unstable on my P.Lindberg Welding System?
- S
  steven57Aug 9, 2025
  An unstable welding arc, or excessive spatter, in your P.Lindberg Welding System can stem from several causes. It could be due to a power cable that is too thin, leading to unstable power. Replacing the cable might solve the issue. Alternatively, the voltage may be too low, in which case, increasing the voltage is recommended. Finally, high resistance on the wire feeder can also cause this problem; try cleaning or replacing the wire feeder.
A
Ann ThomasAug 14, 2025
What to do if the yellow indicator light is lit on P.Lindberg Extremig 130?
- S
  sandrapeckAug 14, 2025
  If the yellow indicator light is illuminated on your P.Lindberg Welding System, it could indicate several issues. The welding voltage might be too high (more than 15%) or too low (less than 15%). To resolve a high voltage issue, switch off the power, check the power supply, and restart the welding apparatus once the power has returned to normal. Overheating may also trigger the light; this could be due to a non-functional ventilation system, so check the fan and repair any faults if needed, or due to excessive temperature, or due to operating the equipment continuously for longer than recommended, so let the equipment cool down.
A
andrewosborneAug 19, 2025
How to troubleshoot a P.Lindberg Extremig 130 Welding System when the wire feed motor isn't working properly?
- M
  mark17Aug 19, 2025
  If the wire feed motor in your P.Lindberg Welding System isn't functioning correctly, consider these potential causes: * The potentiometer may not be set correctly, so rectify it. * The nozzle might be blocked, requiring a replacement. * The feed reel could be loose; tighten the bolts to secure it.
N
nrobinsonAug 25, 2025
What to do if there is no shielding gas in P.Lindberg Extremig 130 Welding System?
- T
  Tyler WrightAug 25, 2025
  If there is no shielding gas in your P.Lindberg Welding System, it might be because: * The gun is not securely in position, so rectify it. * The gas hose is compressed or blocked, so rectify it. * The gas hose has a leak, so rectify it.
S
Samuel WilliamsAug 29, 2025
Why the welding arc cannot be controlled in P.Lindberg Extremig 130?
- T
  Theodore GarciaAug 29, 2025
  If you're having trouble controlling the welding arc with your P.Lindberg Welding System, it could be due to a poor earth connection, so check and adjust it. Alternatively, the workpiece may be dirty, greasy, or rusty, so clean it.
P
Patricia WiseSep 3, 2025
What to do if the fan does not work in P.Lindberg Extremig 130 Welding System?
- M
  Margaret WhiteSep 3, 2025
  If the fan in your P.Lindberg Welding System isn't working or is revolving very slowly, the switch might be broken, so replace the switch. The fan itself could also be broken, requiring repair or replacement. Finally, the cable may be defective or have fallen off, so inspect the connection.

P.Lindberg Extremig 130 Specifications

General

Brand	P.Lindberg
Model	Extremig 130
Category	Welding System
Language	English

P.Lindberg Extremig 130 - User Manual

Table of Contents

Questions and Answers

P.Lindberg Extremig 130 Specifications