RL56
– Spray gun 350 bar – 35 MPa
Technical manual :
E 132
Guns suitable for use up to 350 bar – 35 MPa rated pressure pumps.
No fluid passage upon trigger release.
New mechanical device with double connecting rods to guarantee less strain when opening and holding
DN10
TECHNICAL SPECIFICATIONS
P/N
RATED
PRESSURE
bar - MPa
PERMISSIBLE
PRESSURE
bar - MPa
MAX FLOW
RATE
I/min
(1) MAX
TEMPERATURE
°C
INLET
OUTLET
WEIGHT
gr
30.4500.10
350 - 35 390 - 39 30 160 G3/8 G1/4 FF 660
(1) The gun has been designed for continuous use, at a water temperature of 90°C (195°F). It can resist a t the max
temperature of 160°C (320°F) for short periods only , as, when the gun shuts off, the heater continues to transmit the heat
to the water, thus increasing both temperature and pressure up to high, dangerous values.
Using the gun at a water temperature higher than 60°C involves for the operator the use of adequate sa fety devices,
such as gloves, glasses, etc.
Instruction manual, maintenance, installation, spare parts.
For a correct utilization, follow the directions of this manual
Re-print them on the Use and Maintenance booklet of the machine.
n. 12.9132.00
30.4500.10 RL56 G3/8 G1/4 FF
- Covered by shockproof plastic semi-housings.
- Sst seat and ball.
- Internal structure in brass and Sst.
- Ergonomic construction.
- Minimum fatigue for trigger opening and use
- New mechanical opening device with double connecting rods
- New trigger design, rotating on a fixed pin to guarantee better
To Next Page
Need help?
General
