select when it is necessary to
engage a gear.
• The transmission will exit Neutral
Coast Mode and reengage an
appropriate gear under any of the
following conditions:
• Vehicle brakes are applied
• Driver depresses accelerator
pedal
• Cruise control is canceled
• A mode other than Drive is
selected
• Driver performs up/downshift
requests
• Cruise high or low set speeds
are exceeded
• Maximum vehicle grade is
exceeded
• Request by an adaptive cruise
system
• Various brand names may be used
for Neutral Coast systems.
Urge to Move
Urge to Move allows the vehicle to
automatically start moving when the
transmission is in gear and the driver
releases the service brake. After the
vehicle has launched the vehicle will creep
at a constant speed at engine idle without
the need to apply the accelerator pedal.
The configuration is useful for stop and go
applications allowing the vehicle to launch
and creep without applying the accelerator.
Creep Mode
Creep allows the vehicle to be driven at a
constant speed at engine idle without the
need to apply the accelerator pedal. The
configuration is useful for slow speed
applications where steady vehicle speed is
required. Upshifts and downshifts can be
requested to increase or decrease vehicle
speed.
DRIVING - Features
24 Y53-1272-1B1 (08/17)
2
To Next Page
