PacComm TINY-2 - Page 72

PACKET CONTROLLER COMMANDS Command List
Disconnect Command Continued)
Other commands may be entered while the disconnect is taking
place, although connects are disallowed until the disconnect 1s
completed. If the retry count is exceeded while waiting for the
other side to acknowledge, the packet controller moves to the
disconnected state. If a disconnect command is entered while the
packet controller is disconnecting, the retry count is immediately
set to the maximum number. In either case, the disconnect mes-
sage is:
*** retry count exceeded
*** DISCONNECTED
Disconnect messages are not displayed when the packet control-
ler is in Transparent Mode.
iclass - Optional parameter, class identifier, one of the following:
: Asynec display chronous port parameters
Bbs display PMS parameters
fharacter display special characters
ealth display health counters and LED status
Id display ID parameters
Link display link parameters
i Monitor display monitor parameters
i Printer display printer parameters
:
Timing
display
timing
parameters
DISPlay
is
an
immediate
command,
and
with
no
class
parameter
will
cause
all
control
parameters
and
their
current
values
to
be
displayed.
omd:DISP<CR>
Sub-groups
of
related
parameters
can
be
displayed
by
specifying
the optional
parameter-class.
Individual
parameters
can
be
displayed
by
entering
the
parameter
name
with
no options
This
value
is
used
to
avoid
collisions
with
digip
.T
packet
controller
will
wait
the
default
wait
time
after
last
hearing
data
on
the
channel
before
it
begins
its
keyup
sequence,
unless
it
is
waiting
to
transmit
digipeated
packets.
If
all
stations
specify
a
proper
wait
time
the
digipeater
will
capture
the
frequency
every
time
it
has
data
to
send,
since
digipeated
packets
are
sent
without
this
delay.
Operating
Manual,
4th
Ed.
©
PacComm,
1990
65