PacComm TINY-2 - Page 73

PACKET CONTROLLER COMMANDS Command List
‘ON - Characters received from the computer or terminal are
: echoed by the packet controller.
(OFF - Characters are notechoed. ana
This command controls local echoing by the packet controller
when it is in Command or Converse Mode. Local echoing is
disabled in Transparent Mode. H you don’t see what you type, you
should set Echo ON. Ifyou see two copies of everything you type,
set Echo OFF.
in __ Message number to be edited. ;
ito-callsign revised callsign to be placed in "TO? location. |
'@-callsign -_ _revised callsign to be placed in’@ BBS: location.
headers to allow teaddressing of messages ines the TO:
callsign) and revising the ign of the ’@ BBS’ field. The
EDithdr command will accept either two or three parameters; the
message number and either or both calisigns are required. It does
not
allow
editing
the
BID.
If
the
parameters
are
not
correct,
the
following message will be displayed:
Parameters are missing
Msg
#
Stat
Date
Time
From
@
BBS
Subject
4
T
07/15/90
09:54
WIAW
WS4Z
@W4DPH
VE
tests
New message header
Msg # Stat Date Time From @ BBS Subject
@W4DPH VE tests
To
4
T
07/15/90
09:54
W4MUA
WS4Z
Similarly,
to
revise
only
the’@
BBS:’
callsign
of
message
6,
enter:
fresnssestesnsenseendVectwacsovssessosseceaneeccusntennan
ftcansarernoraroniTrcsovarersanmrtertesecennesenenaatPaversenpasasssenectevasne
PPrcetenseeareseeenee
‘omd:EDithdr
6
@W4DPH
<CR>
jemd:EDithdr
3
NAUQQ
@KOZXF
<CR>
To
remove
the
callsign
in
the’@
BBS’
field
in
message
2
and
leave
ield blank,
enter
the following:
The
PMS
will
respond
with
the
’before’
and
after’
displays
in
each
case.
,
66 Operating Manual, 4th Ed. © PacComm, 1990