- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲ INSTRUCTION MANUAL
MEGA-T300 Abrasive Cutter
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 520-882-6598 Fax +1 520-882-6599 email: pace@metallographic.com Web: http://www.metallographic.com
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
4.0 Start-up and Operation
4.1 General
The MEGA-T300 is a manual wheel and manual table feed cutter.
12
4.2 Control Panel
Coolant
ON/OFF
Cutting wheel ON/: Starts the cutting wheel.
Cutting wheel OFF/: Stops the cutting wheel (inductive brake engages to slow
wheel). Hood cannot be opened until safety lock releases in
approximately 5 seconds after pressing the stop button.
Coolant ON/OFF: Operates the coolant pump in Auto or Manual mode.
Light ON/OFF: Turns inside chamber light On or Off.
Cutting
wheel (ON)
Light
ON/OFF
Cutting
wheel (OFF)
Power
Light
To Next Page
Loading...