- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲ INSTRUCTION MANUAL
MEGA-T300 Abrasive Cutter
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 520-882-6598 Fax +1 520-882-6599 email: pace@metallographic.com Web: http://www.metallographic.com
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
MG-H
65 mm (2.6-inch) height adapter for either MIG-
01 or MG15-01 vertical clamping vises
MG-TB
Vertical clamping vise t-slot bolt and nut
MG-VW
Vertical clamping vise adjustment t-wrench
MEG-TS
T-slot nuts (2/set)
QCR-1100
Right quick clamping vise for MEGA-T300
abrasive cutter
QCL-1100
Left quick clamping vise for MEGA-T300
abrasive cutter
MG-0159
Mechanical stop for cutting repetitive
samples
Part no. Descripon Images
Vice Components
40
To Next Page
Loading...