Pace Technologies NANO 2000T - Safety Test Procedure

To Next Page

To Previous Page

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲ INSTRUCTION MANUAL

3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 520-882-6598 Fax +1 520-882-6599 email: pace@metallographic.com Web: http://www.metallographic.com

Please read this instruction manual carefully and follow all installation, operating and safety guidelines.

NANO 2000T Polisher

3.4 Safety Test

Examine and verify that the NANO 2000T safety devices and operating performance are in

good working condition prior to use. The following safety check is considered important:

Test:

Activate main switch.

Depress emergency stop switch.

Proper

Response:

Machine powers down.

Malfunction: Machine does not lose power.

Corrective

measure:

If system does not power down,

disconnect power supply cord and call

service technician.

Emergency stop switch