8
Step Six: (see figure 6)
Remove the 2 Phillips head screws (L) from the right handle bar upright.
Install the water bottle cage using screws (L) as shown in figure 6.
Step Seven: (see figure 7)
Position the grey motor cover as shown in figure 7.
Use two #8 x 3/8 screws from the hardware kit to
secure the motor cover at the two points “M” in fig. 7.
Press down at both points “N” to secure the Velcro
pads.
Figure 6
Figure 7
Serial
Number
To Next Page
Loading...
