18
6. LOCKING THE SHARK Most SHARKs are supplied with a factory programmed
LOCK Feature that prevents unauthorized people from turning the SHARK on.
TO LOCK:
While the power is ON, press and hold the Power button for 4 seconds.
The horn will sound a short beep and all LED's will fl ash briefl y. The
powerchair will then turn off.
TO UNLOCK:
While the SHARK is locked, press the Power button to turn the SHARK
on. All LED's will fl ash briefl y. The LED's will then perform a right-
to-left "chase". Press the Horn button twice before the timer completes
its pass (approximately 10 seconds). The current state-of-charge will
then be displayed and SHARK may be operated normally.
Note: If the user does not press the Horn button twice within the time
limit, the Horn will sound a short beep and SHARK will turn itself off. The unlock sequence must
be completed successfully before the SHARK will drive again normally.
To Next Page
Loading...
