Need help?Do you have a question about the Pacific PTV3606 and is the answer not in the manual?
Safety precautions and notices for servicing the television receiver.
Information required when ordering replacement parts.
Crucial notes regarding silicon grease usage for ICs and transistors.
Specifications for the CRT, size, type, and deflection system.
Details about the broadcasting system, tuner, and channel coverage.
Power source, consumption, and safety/radiation regulations.
Operating conditions and on-screen menu features for display adjustments.
Supported OSD languages and clock/timer settings.
Comprehensive list of remote control functions.
List of general product features.
List of accessories included with the television unit.
Details on input/output terminals and their functions.
Physical dimensions and weight of the television unit.
Specifications of the master carton used for packaging.
Information on gift box design, materials used, and their origin.
Details regarding compliance with environmental standards like Pb-free and Cd-free.
Step-by-step guide for safely removing and installing the anode cap.
Procedures for removing and installing flat package ICs with safety notes.
Overview of service modes for repair, examination, and adjustment.
Procedure to check the total power-on hours of the unit.
Guide for entering data, selecting addresses, and initializing after EEPROM replacement.
Safety precautions and measurement tools required for electrical adjustments.
Steps to access and perform adjustments via the on-screen menu.
Procedures for adjusting AGC voltage, cut off, and white balance.
Procedures for adjusting focus, constant voltage, and vertical linearity.
Adjusting horizontal and vertical screen positions for optimal display.
Adjusting vertical size and brightness center for accurate picture display.
Procedures for adjusting contrast, color center, and VCO settings.
Verifying that specific adjustment items are set to their correct fixed values.
Initial rough alignment of static convergence using magnets.
Adjusting purity magnets and deflection yoke for correct color purity.
Fine-tuning static convergence using pole magnets.
Adjusting dynamic convergence using wedges and yoke positioning.
Diagram showing wiring connections for electrical adjustment test points.
Layout of inserted parts on the Main/CRT PCB, viewed from the solder side.
Layout of chip components on the Main/CRT PCB, viewed from the solder side.
Circuit diagram for the MICON/TUNER section of the main PCB.
Circuit diagram for the CHROMA/SIF/VIF/21PIN section of the main PCB.
Circuit diagram for the Sound Amplifier and Front AV section of the main PCB.
Circuit diagram for the Deflection and CRT section of the main PCB.
Circuit diagram for the Power Supply section of the main PCB.
Oscilloscope waveform examples for the MICON/TUNER section.
Oscilloscope waveform examples for the CHROMA/SIF/VIF/21PIN section.
Oscilloscope waveform examples for the Sound AMP/Front AV section.
Oscilloscope waveform examples for the DEFLECTION/CRT section.
Lists of resistors, diodes, ICs, and transistors with part numbers and descriptions.
Lists of capacitors, coils, transformers, jacks, and switches with part numbers.
Lists of PCB assemblies, miscellaneous items, and definitions for capacitor types.
To Next Page
General