EasyManua.ls Logo

Pacific T36 User Manual

Default Icon
21 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Question and Answer IconNeed help?

Do you have a question about the Pacific T36 and is the answer not in the manual?

Pacific T36 Specifications

General IconGeneral
BrandPacific
ModelT36
CategoryVentilation Hood
LanguageEnglish

Summary

WARNING

General Safety Warnings

Reduce risk of fire, electric shock, or injury by observing safety guidelines.

Ventilation Caution

For general ventilation only, avoid hazardous materials or vapors.

Grease Fire Prevention

Reduce risk of range top grease fires by following specific precautions.

Grease Fire Injury Prevention

Observe safety measures to prevent injury during a range top grease fire.

INSTALLATION

Mounting Heights

Specifies minimum and maximum mounting heights for the range hood.

Ducting Requirements

Details duct size requirements and calculation for duct run length.

Fire Hazard Warning

Never terminate duct work in wall/ceiling spaces; use metal ductwork only.

Electrical Safety Warning

All electrical work by qualified persons; disconnect power before working.

Electrical Supply Requirements

Requirements for 120V 60Hz supply and branch circuit protection.

Cable Lock

Mentions cable locking connector may be required by local codes.

OPERATION

Product Features

Lists key features like auto cleaning, fan speed, light adjustment, and delay off.

Washing Indicator

Explains '-C-' indicator for washing and '888' for water removal.

CLEANING

Automatic Cleaning Programme

Explains the functions and operation of the automatic cleaning program.

Cleaning Functions

Describes how the cleaning process uses cleaner and motor speed.

Cleaning Operating Instructions

Step-by-step guide for using the automatic cleaning program.

Cleaning Precautions

Safety and usage advice for the cleaning program.

MAINTENANCE

Power Disconnection for Maintenance

Always disconnect power supply before cleaning the unit.

Exterior and Interior Cleaning

Clean exterior and interior with non-abrasive cleanser.

Fan Grille Maintenance

Detach fan protection grille for cleaning.

Oil Cup Cleaning

Detach and clean the oil cup regularly to collect grease.

REPLACE THE TUBE STARTER

INSTALL SNAP-LOCK WIRE CONNECTOR

OTHERS

Repair Service Guidelines

Repair should only be done by manufacturer or qualified technician.

Smoke and Fume Discharge

Hazardous smoke/fume must be discharged outside the kitchen.

Kitchen Ventilation

Maintain good air ventilation in the kitchen while using the range hood.

Cleaning Safety

It is dangerous if cleaning is not done per manual instructions.

INSTALLATION RULES

Pre-installation Check

Check accessories, warranty, oil cup, duct fittings; test light and motor.

Surrounding Environment

Close doors/windows to prevent airflow interference affecting suction.

Installation Height

Recommended height is 65-75cm from stovetop to hood bottom.

Body Leveling

Ensure the body is level to prevent oil leakage from the air chamber.

Exhaust Duct

Use 6-inch diameter duct and avoid too many bends for efficiency.

FUNCTION INTRODUCTION

38-Second Auto Cleaning

38-second automatic cleaning function completes one cycle.

Three-Speed Fan Adjustment

Three-speed fan adjustment for more convenient cooking.

Two-Level Light Adjustment

Two-level brightness selection for the light.

Timed Delay Shut-off

Three-stage timed delay shut-off for better smoke removal.

TiO2 Sterilization & Deodorization

Timed TiO2 sterilization/deodorization for health.

Washing Reminder

Indicator prompts washing after 10 hours of continuous use without cleaning.

Water Removal Prompt

Prompt to remove water after more than two auto-cleaning cycles.

LED Indicator Lights

Explains '-C-' and '888' indicators for washing and water removal.

AUTOMATIC CLEANING FUNCTION DESCRIPTION

Function Description

How the cleaning process uses cleaner and motor speed to clean the interior.

Operating Instructions

Steps to mix cleaner and water and operate the auto-clean function.

Precautions and Warnings

Important advice and warnings for using the auto-clean feature.

REPLACE TUBE STARTER

INSTALL MICRO SWITCH

MAINTENANCE AND CLEANING

General Maintenance and Cleaning

General guidance on cleaning and maintenance procedures.

Power Disconnection for Cleaning

Always disconnect power before cleaning.

Regular Cleaning Advice

Clean interior/exterior regularly, avoid abrasive cleaners.

Fan Grille Cleaning Procedure

Detach fan grille with screwdriver for cleaning, then reinstall.

Oil Collector Cleaning

Detach motor oil collector by rotating counter-clockwise, then clockwise to reinstall.

Central Oil Cup Cleaning

Detach the central oil cup for regular cleaning.

CIRCUIT DIAGRAM

Related product manuals