Dear Customer,
We, at Laguna, hope you enjoy using your newPacifica Wheel and hope it meets and exceeds all your expectations.
Prior to shipping, your wheel was thoroughly inspected and tested to make sure it meets our very strict quality standards.
However, due to the nature of mechanical systems, from time to time you may experience minor problems that could
affect the performance of your wheel. Below, you will find a basic troubleshooting guide to help you overcome any minor
problems that you may encounter. If after using this guide the problem persists, please call our Customer Service center
at Laguna. We would be more than happy to go over these and other steps with you to ensure that your wheel is up and
running in no time at all.
Wheel won’t turn on: 1. Make sure wheel is plugged in and the plug at the back of your
control box is plugged in tight.
2. Make sure the breaker in your home breaker box has not been
tripped.
3. Make sure the circuit breaker in the wheel is not tripped.
4. Check on/off switch to make sure it is working properly.
5. Check the indicator light to make sure it lights up when the On/Off
button is pushed.
Light comes on but wheel head won’t turn: 1. Make sure the direction switch is set to either the forward or reverse
position.
2. Also check to see if you can hear the motor running. If the motor is
running and the wheel head is not turning, the belt may have come
off the pulley. In that case, call Axner’s customer service center for
further instructions.
Wheel is making excessive noise: 1. Make sure splash pan is set properly in place. If noise continues
remove splash pan and run the wheel to see if it still makes noise.
2. With the wheel off and the direction switch on neutral spin the wheel
head manually and see if you can still hear the noise. Try to deter-
mine if the noise is coming from the front or the back.
Wheel squeals or has intermitent power. 1. After you have owned your wheel a while
you may need to check
belt tension. Belt should deflect no more than one inch.
Squeal is a result of the belt slipping against the pulley instead of
moving with it. Power transfer is lost when belt slips (usually when
centering.) Read on for instructions..
.
Allen Wrench
Bat pins
Aluminum Wheel Head
Circuit breaker
Power Light and On/Off button
Forward/Reverse Switch
Two Piece Splash Pan
Belt
Pulley
Motor
Getting to know your Pacifica Wheel
1 Two piece Splashpan
1 Allen Wrench-T-Handle 5/32
1 13” Wheelhead
2 bat pins and wingnuts.
1 Pacifica Footpedal
1 Owner’s Manual
Parts List
The following parts have been shipped
Foot pedal
Control box
Troubleshooting Guide for Pacifica Wheel
To Next Page
Loading...