Need help?Do you have a question about the Packard Bell FPS-100 and is the answer not in the manual?
Audio| total output power | 12W RMS |
|---|---|
| satellites power | 3W RMS per channel |
| subwoofer power | 6W RMS per channel |
| signal to noise ratio | 55dB |
| frequency response | 70Hz - 18KHz |
Drivers| subwoofer driver | 4” Subwoofer |
|---|---|
| satellites driver | Slab[TM] flat panel satellites |
Impedance and Frequency| impedance | 4 ohms |
|---|---|
| satellites frequency response | 200Hz - 18KHz |
| subwoofer frequency response | 70Hz - 250Hz |
Power Supply| power supply | AC 230V / 50Hz |
|---|
Dimensions| satellites width | 140mm |
|---|---|
| satellites height | 200mm |
| satellites depth | 20mm |
| subwoofer width | 130mm |
| subwoofer height | 242mm |
| subwoofer depth | 199mm |
Key safety instructions for operating the equipment, ensuring proper connections, and avoiding hazards.
Plug the speaker stereo jack from the satellite speakers into the line out socket of the subwoofer.
Plug the line-in connector into the line-out socket of your audio source.
Connect the subwoofer to mains power after ensuring speakers are off; adjust volume and bass.
Detailed specifications for total output power, drivers, impedance, frequency response, and dimensions.
Information on obtaining accessories, spares, and technical support via Partmaster Direct and a helpline.
To Next Page