Packard Bell FPS-100 - Speaker Setup and Connection; Connect Speakers to Subwoofer; Connect to Audio Source; Power Connection and Adjustment

Plug the line in connector into the line out socket
of your audio source.
2
3 4
Make sure the power switch on the speakers is
switched off, then plug the subwoofer into the
mains.
Plug the speaker stereo jack from the satellite
speakers into the line out socket of the
subwoofer.
1
Volume
Bass
On
Off
To adjust the volume and bass levels,
turn the dials on the volume controller. Switch
your speakers on by sliding the ON/OFF
switch to ON.
Volume
Bass
On
Off
Packard bell FPS-100v2.qxd 05/12/2002 16:05 Page 3