What does 'Primary Master Hard Disk Error' mean on Packard Bell oneTwo M3850?
This error on Packard Bell Desktop appears when the BIOS is trying to detect and configure IDE/ATAPI devices during POST, but the IDE/ATAPI device configured as Primary Master couldn't be properly initialized.
What does 'Checking NVRAM... Update Failed' mean on Packard Bell oneTwo M3850?
General| RAM | 4 GB DDR3 |
|---|---|
| Operating System | Windows 7 Home Premium |
| Network | 10/100/1000 Mbps Ethernet |
| Display | 21.5-inch Full HD |
| Graphics | Intel HD Graphics |
| Connectivity | Wi-Fi 802.11b/g/n |
| Ports | USB 2.0, HDMI, Audio jacks |
| Optical Drive | DVD Super Multi |
| Audio | Integrated HD Audio |
Details the processor models, clock speed, cache, cores, socket, and TDP.
Provides specifications for memory controller, DIMM slots, maximum memory, data rate, and supported brands.
Details HDD controller, form factor, interface, and supported capacities with specific models.
Details LCD panel specifications like size, type, resolution, backlight, and touchscreen support.
Lists the maximum output power and supported models for the power supply unit.
Explains the CMOS Setup Utility, its purpose, and when to use it for hardware configuration.
Provides step-by-step instructions on how to enter the BIOS Setup Utility during system boot.
Covers settings for system date, time, AHCI port configuration, and POST error handling.
Explains boot device priority, quick boot, quiet boot, and boot sector virus protection settings.
Details features like AMD Cool 'n' Quiet, AMD-V, Memory Hole Remapping, and Hybrid SLI.
Covers enabling/disabling onboard SATA, USB, graphics, audio, and LAN controllers.
Details ACPI Suspend Mode, Deep Power Off Mode, and wake-up options.
Enables setting supervisor and user passwords for system security and BIOS access.
Provides step-by-step instructions for disassembling the computer's components.
Guide to removing the rear cover, including releasing plastic snaps.
Detailed guide on safely removing the CPU, including handling the retention lever.
Steps to disconnect cables and remove the mainboard after other components are removed.
Procedure to disconnect power cables and remove the power supply unit (PSU).
Detailed steps for disconnecting cables and removing the LCD assembly.
Procedure to remove the main chassis from the LCD module after releasing cables and tapes.
Steps to gather details, recreate failure, and refer to other checks for diagnosing hardware issues.
Provides procedures for checking system power and performing external inspections.
Checks power cable connection and voltage settings if the system does not power on.
Details steps for internal inspection, verifying component seating and cable connections.
Describes how the setup utility indicates errors via messages or beep codes during POST.
Explains POST error messages, their causes, and recommendations for troubleshooting.
Lists beep codes, their status, and possible causes when no error message is displayed.
Provides a procedure to isolate failing FRUs when the cause of a problem is not clear.
Instructions on how to recover the system BIOS when it is damaged or corrupted.
Procedure to clear CMOS data and reset BIOS settings, including the supervisor password.
A comprehensive list of Field Replaceable Units (FRUs) with part numbers for ordering.
To Next Page
