Palazzani
Palazzani Industrie spa
OM 386 pag 1 Cap 3
CAP. 3° NORMAL USE CONDITIONS
3.1 LOAD AND UNLOAD ON TRUCK.
a) By crane
take the tensors or the equipment fixing stripes off.
hook the 4 eyebolts on the top of the stabilizing legs with proper loading
ropes (min half weight each) (Fig. 3.1)
lift the machine and go out with truck
Fig. 3.1
b) Self-loading (if possible).
See also the Chap. 3.24
stop the lorry on level and rough ground
rotate the stabilizing legs in the hole 2 (see Fig. 1.2)
start the diesel engine.
turn the selecting key of the ground control panel on the "stabiling-legs"
symbol (part 6 of Fig. 3.2)
extend the telescopic section of the stabilizar, lock it by means of the pins
and lower the stabilizer on the ground.
before lay the plates on the ground, put the proper rolling chariots (see Fig.
3.34).
disengage the machine from the lorry and lowering the stabilizing-legs,
hoist the platform from the lorry
slowly, drive the lorry out of the platform
lift the stabilisers as described in paragraph 3.12 with the belt control
To Next Page
Loading...