5
ENGLISH
Profile
®
Coreless Filter Elements
Operating and Installation Procedures
(b) Extract the lower core (1) from the filter
housing by lifting it up and out of the
standpipe socket.
(c) Clean and examine the lower core
knife-edge and renew O-ring seal (5)
before re-assembly and installation.
Housing O-ring seal:
‘J’ option - EPR and or options
‘HB’ option - Fluorocarbon
Elastomer
8. SECTION OF PROFILE CORELESS
FILTER ASSEMBLY
FIGURE 1
9. DISPOSAL OF USED FILTERS
Disposal of the used filters should be in line
with national legislation and local regulatory
requirements for the materials of construction
(see materials listed above) and due
consideration must be made to the nature of
contaminants on the filter as the result of use.
10. SCIENTIFIC AND LABORATORY
SERVICES
Pall operates a technical service to assist
in the application of all filter products.
This service is readily available to you and we
welcome your questions so that we can help.
In addition, a full network of technical
representatives is available throughout
the world.
To Next Page
Loading...
Need help?
General
