Need help?Do you have a question about the Pallas Duo and is the answer not in the manual?
Specifies minimum and maximum water pressure requirements for correct valve regeneration.
Ensures proper power supply connection and safety, requiring a qualified person for cable repairs.
Troubleshooting steps for when the softener does not regenerate, covering electrical, timer, motor, and meter issues.
Troubleshooting for failure to draw brine, focusing on flow control, injector, pressure, and internal leaks.
Identifies causes and remedies for hard water issues, including bypass, salt level, and injector problems.
Addresses continuous drain flow due to programming errors, foreign material, or control leaks.
Explains causes of water pressure loss, such as iron buildup, clogged resin, or control inlet issues.
Covers scenarios where the valve fails to regenerate, pointing to controller, microswitch, or cam defects.
General| Cold Water Temperature | 5-10°C |
|---|---|
| Voltage | 220-240V |
| Child Lock | Yes |
| Temperature Control | Yes |
| Cooling Technology | Compressor Cooling |
| Hot Water Temperature | 90-95°C |
| Material | Plastic |
To Next Page
