7. Change the port number to the one selected above (i.e., Com 7)
8. Tap Ok
9. Tap Accept
Your handheld device is now setup to work with Pocket Verifier and Pocket
Spectrum!
Note:
If you are on the sales screen when the Pocket Spectrum is off and you would like to read a card,
turn on the printer, wait for the single beep and linefeed, then click on the blue Bluetooth icon at
the top right of the screen. The icon will turn red briefly until communications are established.
Pocket Verifier Addendum for TREO 700 6
To Next Page
Loading...
