Setting Up Pocket Spectrum
There are only four simple steps for setting up the Pocket Spectrum to work with the
Verizon TREO700. They are:
1. Resetting your Pocket Spectrum to allow pairing
2. Pairing the Pocket Spectrum with your Handheld TREO Device
3. Setting the Bluetooth COM Port on your Handheld TREO Device, and
4. Setting the COM Port in Pocket Verifier
Each of these is outlined below.
Step 1: Resetting your Pocket Spectrum to allow pairing
Before you can pair the Pocket Spectrum with your iPAQ6315, the Pocket Spectrum
should first be reset. To do this...
1. Turn off the Pocket Spectrum (if it is already on).
2. Plug in the charger for the Pocket Spectrum.
3. Press and Hold
the ON button for at least 3 seconds.
4. When the paper starts advancing, release the ON button.
A diagnostic sheet will be printed.
5. After the print out completes, the printer is initialized.
Step 2: Pairing the Pocket Spectrum with your Handheld TREO Device
1. From the Start menu select Settings > Connections > Bluetooth
2. Turn on Bluetooth
Pocket Verifier Addendum for TREO 700 3
To Next Page
Loading...
