3
ROBATA 72/54 CORTEN FIRE | Owner and Installation Manual
POSITIONING GAS & ELECTRICAL SUPPLY
Robata has an open base
through which you can
bring a gas or propane
line and electrical service.
See Fig. 1 (hatched areas)
Please make sure that the
gas line and power supply
are located only within these
areas. This will ensure that the
nal position of the unit will
not be compromised.
FIG 1. BASE DIAGRAMS
See page 12 of this
manual for Gas Installation
Requirements
This appliance requires
110V AC power supply in
the form of an outdoor
receptacle installed inside
the unit body.
ATTENTION:
Gas and electrical lines
must be installed by
licensed contractors in
compliance with local
codes. Main power must
be o when connecting
to main electrical power
supply or performing
service.
OPENINGS FOR GAS
AND ELECRICAL
LOCATION OF BURNER
ROBATA 54
CORTEN
19”
54”
8”24”
4”
18 1/4”
LIN-36 BURNER
ROBATA 72
CORTEN
72”
8”
24” 18 1/4”
LIN-48 BURNER
To Next Page
