To Next PageTo Next PageWhy is my PALSON Coffee Maker leaking water from the bottom?
Water may leak from the lower part of your PALSON Coffee Maker due to two main reasons: either there's too much water in the drip tray, in which case you should clean it, or the coffee maker isn't working correctly, and you should contact the authorized service center.
What to do if my PALSON Coffee Maker tank loses water?
If the tank of your PALSON Coffee Maker is losing water, make sure the tank is properly aligned with the opening of the preparation container. Also, ensure that the water level in the tank is below the MAX mark.
Why does the steam not make froth in my PALSON Coffee Maker?
The steam in your PALSON Coffee Maker might not be frothing because the steam indicator (green light) is not on. Steam can only create froth when this light is active. Also, the cup might be too big or have an unsuitable shape; try using a tall, thin cup. Finally, using skimmed milk will prevent frothing; opt for full-cream or semi-skimmed milk instead.
Why does my PALSON Coffee Maker espresso taste like vinegar?
Your PALSON Coffee Maker espresso may taste acidic if the appliance wasn't properly cleaned after descaling mineral sediments; clean the coffee maker's contents several times before using it for the first time. Alternatively, the ground coffee might have been stored improperly, becoming stale. Use freshly ground coffee or keep unused ground coffee in a cold, dry place, and seal open packets well, storing them in the fridge.
What to do if my PALSON Coffee Maker is not working?
If your PALSON Coffee Maker isn't working, first ensure the cable is properly plugged into a socket. If it still doesn't work, contact the authorized service center.
Why is water leaking from the filter of my PALSON Coffee Maker?
If water is leaking from the outer part of the filter in your PALSON Coffee Maker, it is likely due to ground coffee on the edge of the filter. Remove the coffee grounds from the edge.
Why are the metal parts of my PALSON Coffee Maker tank rusty?
The metal parts of your PALSON Coffee Maker tank might be rusty because an unsuitable de-scaler was used, which corroded the metal. Use the de-scaler recommended by the manufacturer.
General| Product Type | Espresso Machine |
|---|---|
| Model | Arabica |
| Power | 850 W |
| Material | Stainless Steel |
| Pump Pressure | 15 bar |
| Type | Espresso |
| Water Tank Capacity | 1.2 Litres |
