13
Check that the power supply always corresponds to the indicated voltage in the product plate. It is preferable to connect
the machine to the outlet with a 30 mA grounded protective switch at a maximum.
WHAT IS A PRESSURE WATER WASHER?
A pressure water washer is essentially an electric motor that conducts a piston unit that makes water pass through a
small nozzle.
A pressurized jet of water is created in this way. This provides enormous cleaning power.
A pressure water washer can be used for multiple tasks at home and in the garden. It offers an efficient method of
cleaning different types of surfaces without any effort. All water pressure washers (apart from hot water systems) are
APPLICATIONS
Main applications for this device are domestic cleaning tasks such as:
DESCRIPTION
metal and plastic materials.
Check the suitability of the cleaning surface. The manufacturer assumes no liability for damage caused by inappropriate use.
WAND ASSEMBLY (DIAGRAM A)
Connect the wand and the pistol (6 and 7) by pushing the bayonet into the nozzle (6) towards the cap of the pistol (7)
and mounting it in position (turning it clockwise until its position is blocked). Assembly must be carried out before using
come off the pistol.
Always remove or replace parts while the pressure water washer is disconnected and unplugged from outlet power.
WATER OUTLET CONNECTION (DIAGRAM B)
Screw the high pressure hose (5) in the water outlet (4).
Be sure the connector is firmly affixed (but not tightened excessively).
The minimum supply hose length (not included) advised for maximum user comfort is 5 meters with a 12.5 (1/2”) mm
diameter to prevent delay pressure and any potential damage associated with the pressure water washer.
USAGE INSTRUCTIONS
1. Connect the supplied hose to the water outlet (Diagram B).
2. Connect the plug to a grounded outlet.
Never begin the pressure water washer’s operation without supplying connected water. Keep the pistol trigger tightened
(7) until all the water pressure air and water begin to flow. As soon as the water begins to flow out from the nozzle
4. Set the power switch in the “I” position (on).
Never try to open the pressure water cleaner’s cover during operation.
CONNECTION AND DISCONNECTION
To Next Page
Loading...
