Panamax MIW-POWER-PRO-PFP

To Next Page

MIW-POWER-PRO-PFP INSTALLATION INSTRUCTIONS

STEP 1:

Select a location close to the equipment. In the case of a at panel

display, the recommended location is one that is behind the device

and hidden from view once the Plasma TV is mounted. Cut a 4”

wide by 3 3/4” high hole in the wall for the outlet box.

STEP 2:

Run the building wire (e.g. Romex) through a rear opening in

the outlet box (not included). No more than 1” of wire sheath

should extend into the outlet box. 3” of wire should be able to

extend beyond the opening of the outlet box. Install the outlet

box in the hole.

STEP 3:

Strip building wire. Using the included wire nuts, rst connect

the ground wires - green insulated on the MlW-Power-Pro-PFP

and bare copper on the building wire. Then connect the neutral

wires (white), then the hot wires (black).

STEP 4:

Neatly fold the AC wires as you install the MIW-Power-Pro-PFP

in the outlet box and secure with the included screws.

STEP 5:

Turn the power on to the circuit. The blue Power indicator

should light up, indicating the outlet is ready for use.

NOTES:

In the event of a hazardous voltage situation, the red Unsafe

Voltage indicator will light up until the voltage returns to a safe

level.

(Outlet boxes

not included)

INS00840 REV E 02/10

CAUTION:

Only for use with 15 Amp circuits utilizing a minimum of 14 AWG.

Make sure the circuit is not live before installation. If you are unsure how

to perform this task, please contact an electrician.

Signal Protection Module Usage:

Panamax In-Wall signal protection modules (sold separately),

while not necessary for surge protection in the Max In-Wall

Power-Pro-PFP, may be used to provide a clean looking interface

for the signal lines. When used in the proper manner the modules

also provide total protection to the connected equipment.

Other manuals for Panamax MIW-POWER-PRO-PFP

Datasheet1 page

Need help?

Do you have a question about the Panamax MIW-POWER-PRO-PFP and is the answer not in the manual?

Summary

MIW-POWER-PRO-PFP Installation Instructions

CAUTION and Safety Precautions

Safety warnings for circuit usage, live circuits, and hazardous voltage indication.

Installation Steps

Step-by-step guide for selecting location, wiring, mounting, and powering up the device.

Signal Protection Module Usage

Information on using optional signal protection modules for interface and protection.

MIW-POWER-PRO-PFP Specifications

AC Circuit and Outlet Specifications

Technical details on AC circuit ratings, outlets, connectors, and noise filtration.

Installation Caution and Included Accessories

Warning about installation distance and list of included installation accessories.

Contacting PFPOWER

Contact details and customer relations information for PFPower.