English
3
Press the level switch, and
selectthewaterpressurelevel.
• Each time you press the level switch, the
water pressure level is switched as follows:
1 (weak) → 2 → 3 → 4 → 5 (strong) → 1...
Press
LEVEL
Aboutthewaterpressurelevelmemoryfunction
The last selected water pressure level will be remembered,
fromwhichtheappliancewillstartnexttime.
• When the appliance has not been used for a long time or when
the battery is used up, the water pressure level will return to 1.
4
Placethenozzleinyourmouth,closeyour
mouthgently,andthenturnonthepower
switchtorinseyourteeth.
• You can switch the water pressure
level by pressing the level switch,
even while using the appliance.
• If the main unit is tilted too much, the
water does not come out from the
nozzle.
• During use, be careful not to cover
the air vent with your hand. Otherwise,
the water does not come out from
the nozzle.
* It can also be used in a bath.
Keep your face over the
basin.
Operation time with full water
approx.60seconds.
(When the water pressure level is set to 5)
5
To prevent the water from splashing about, turn
off the power switch while keeping the nozzle
inyourmouth.
• Please clean the appliance after each use. (See page 13.)
Notes
• The appliance does not work during charging.
• Always use new tap water or lukewarm water. (Do not put salt,
mouthwash or other chemicals into the water tank.)
• If you feel the water is cold, use lukewarm water with a temperature
of 40 °C or less.
• For the rst use, turn on the power switch to jet water so that
you can check the water pressure level. (Please start using the
appliance from water pressure level 1.)
• The appliance may not operate in an ambient temperature
approximately 5 °C or lower.
• Do not push the tip of the nozzle too hard against the teeth or
gums. (Except the orthodontic nozzle)
• When you feel that the irritation is strong, turn off the power switch
and use the appliance from water pressure level 1.
• Do not turn on the power switch when the water tank is empty
unless you are drying the moisture inside the main unit.
(Doing so may cause malfunction.)
11