Panasonic 800 Series

English
Charging
• Please wipe off any water droplets from the socket or socket cover.
1
Open the socket cover, and insert the USB plug
(Type-C)oftheUSBcableintothesocketon
themainunit.
If the socket cover comes off
a
While holding the main unit with your hand, press and hold
the socket cover with your thumb so that the soft rubber joint
(mushroom-shaped) of the socket cover is aligned with the
xing hole.
b
As shown in the gure, push the soft rubber joint
(mushroom-shaped) into the xing hole with a SIM ejector pin.
(Do not use a sharp-pointed tool as this may cause damage
to the soft rubber joint or a hand injury.)
c
Make sure that the soft rubber joint (mushroom-shaped) is
fully pushed into the xing hole.
Fixing hole
Soft rubber joint
(mushroom-shaped)
a b c
2
InserttheUSBplug(Type-A)oftheUSBcable
intotheUSBport(Type-A)oftheUSBpower
adaptor.
• Check the direction of the USB plug (Type-A) terminals,
hold the USB plug (Type-A), and insert or pull it out straight.
(Deflection or insertion in a wrong direction may cause
deformation or malfunction.)
3
Insert the USB power adaptor into the
householdoutlet.
2
1
3
4
Chargingiscompletedafterapprox.1hour.
Forsafety,disconnecttheUSBpoweradaptor
from the household outlet after charging is
completed.(Thechargingtimemayvarywith
theremainingbatterycapacity.)
• Remove the USB plug (Type-C) from the socket, and close the
socket cover.
• Charging the battery for more than 1 hour will not affect battery
performance.
• This appliance uses a Lithium-ion battery. Therefore, the service
life of the battery will not be affected even if it is charged after
each use.
9