Panasonic AG-AC160AEN - Adding Shot Marks to Clips; Selecting the Memory Card Slot for Playback

57
Playback
12 Indicators
•
•
In•AVCHD•mode
[
]: Shot mark
This•indicates•that•a•clip•has•a•shot•mark.
(Page•57)
[ ]: Index
This•indicates•that•indexes•have•been•added.•
(Page•61)
[
]: Resume playback display
Displayed•on•clips•on•which•resume•playback•
setting•has•been•applied.
•
•
In•DV•mode
[
]: Shot mark
This•indicates•that•a•clip•has•a•shot•mark.
(Page•57)
[
W
]: Wide
Displayed•on•clips•recorded•in•16:9•angular•
eld.
[
]: Resume playback display
Displayed•on•clips•on•which•resume•playback•
setting•has•been•applied.
[
X
] (Yellow): Defective clip (repairable
clip)
Displayed•on•defective•clips•resulted•from•
turning•off•the•power•during•recording,•etc.•
These•may•be•repaired.•(Page•62)
[
X
] (Red): Defective clip (unrepairable
clip)
Displayed•on•defective•clips•resulted•from•
turning•off•the•power•during•recording,•etc.•
Delete•these•clips•because•they•are•not•
repairable.•If•you•cannot•delete•these•clips,•
format•the•memory•card•with•this•camera.
(Page•13)
[
?
]: Defective clip (clip with unknown
content)
Displayed•on•clips•with•unknown•content•
because•the•content•is•incompatible•with•this•
camera.
[
!
]: Incomplete clip
When•the•recording•capacity•of•one•
clip•exceeds•4•GB•(recording•time•is•
approximately•16•minutes),•the•clip•is•
automatically•split•and•saved•as•another•clip.•
This•is•displayed•on•clips•that•were•not•saved•
successfully•as•associated•clips•due•to•power•
being•switched•off•during•recording,•etc.
•
•
To•display•CLIP•PROPERTY•on•the•
thumbnail•screen,•move•the•cursor•using•the•
OPERATION•lever•to•the•clip•you•want•to•
display•properties•for,•and•press•the•<DISP/
MODE•CHK>•button.•For•details•on•display,•
see•“Clip•information•screen”•(Page•64).•Press•
the•<MENU>•button•while•displaying•the•
properties•to•return•to•the•thumbnail•screen.
Adding shot marks to clips
Adding•shot•marks•[ ]•will•make•it•easier•to•nd•
the•clips•you•are•looking•for.
1
Tilt the OPERATION lever in the < >< >
<
>< > directions to move the cursor to the
clip for which a shot mark is to be added.
2
Press the USER button to which the shot
mark function has been allocated. (Page 87)
To•release•a•shot•mark,•repeat•the•preceding•
steps.
•
•
It•is•not•possible•to•add•shot•marks•to•clips•
shot•using•a•consumer•camcorder•model.
Selecting the memory card slot for
playback
You•can•switch•the•memory•card•slot•for•playback.
1
Press the <SLOT SEL> button when the
thumbnail screen is displayed in the <PB>
mode.