Panasonic AG-HMX100 - Setting 3 D Mode [3 D]

25
Chapter 3 Switching 3D Video
This function allows selection of 3D mode and 3D signal
format.
Select [3D] in the [SETUP] menu using the rotary 1 control,
and set the 3D mode and 3D signal format as described
below using the rotary 2 and 3 controls.
Rotary 1 Rotary 2 Rotary 3 Rotary 4 Rotary 5
720/50p
720/59p
1080/23
1080/50i
1080/59i
OFF
MODE1
MODE2
MODE3-M
MODE3-S
3D MODE
OFF
1080/59i
FORMAT
To select 3D mode
Select 3D mode using the rotary 2 control.
When the current setting is changed, * is added to the
setting value.
If other menu screen is opened with * displayed, the setting
value returns to the previous value without being changed.
When the message [OK?] appears, press the
key.
To cancel the selection, press the
key while holding
down the SHIFT key.
Setting Mode
OFF Regular display mode
MODE1 2-channel switching, L and R outputs
MODE2 2-channel switching, Side By Side signal
output
MODE3-M 4-channel switching, L and R outputs,
master
MODE3-S 4-channel switching, L and R outputs, slave
Setting Screen in 3D Mode
If the 3D mode is set to other than [OFF], [3D] appears
in the Joystick, Rotary Z Control Settings, and 3D Display
Area.
The same content as in 2D mode is displayed in the area
upper than the menu display area, but not used for the
operation.
POS.
MOSAIC SIZE
OFF XY 0
OFF 0
DEFOCUS LEVEL
OFF
MONO
EVENT
VIDEO EFFECTS
CH A
ME TIME PATTERN INT
00 E
2:00 F 3044 WHT
X 128
Z 196 FAN STOP
Y 128
3D
 NOTE
If [MODE3-M] or [MODE3-S] is selected, the settings of video
input sources are fixed as follows: [SDI1] to source 1, [SDI2] to
source 2, [SDI3] to source 3, and [SDI4] to source 4.
The [AUDIO VIDEO] submenu of the [SETUP] menu does not
show any [INPUT] items ( page Vol.1-24).
To select the 3D signal format
When the selected 3D mode is other than [OFF], set
[FORMAT] using the rotary 3 control.
When the selected 3D mode is [OFF], the system format
set in the [VIDEO FORMAT] submenu (
page Vol.1-26)
becomes effective.
 NOTE
If [MODE3-M] or [MODE3-S] is selected, [1080/23] is not •
displayed under the [FORMAT] item, and cannot be selected.
If 3D mode and 3D signal format are changed, the system •
must be restarted.
When the message “TURN POWER OFF” appears, turn off
the power and restart the unit.
Setting 3D Mode [3D]