30
Chapter 4 Operating Environment Setting
To turn on or off the projector power
1
Select [ON] or [OFF] using the rotary 2 control,
and press the key.
2
Press again the key when the message
[OK?] appears.
To control the shutter function of the
projector
1
Select [ON] or [OFF] using the rotary 3 control,
and press the key.
2
Press again the key when the message
[OK?] appears.
Black signals are output from the PGM connector of the
SDI and DVI-D connectors to projectors without shutter
function.
NOTE
If the communication is interrupted during control of the •
projector, operational consistency may not be maintained
between this unit and the projector. (For example, if the
communication cable is disconnected after the shutter is
turned off from the unit, the black signal is output from the
PGM connector.)
This unit monitors the condition of the projector at regular •
intervals.
During projector monitoring, *** appears on the screen,
disabling this unit to control the projector.
To Next Page
Loading...
