Panasonic AJ-PCD2G - Driver Installation; Installing USB Driver for Macintosh

E-12
ENGLI SH
Installing a USB Driver for Windows
Refer to the installation manual in the “Manuals” folder on the CD-ROM for
information on how to install the Windows drivers.
Installing a USB Driver for Macintosh
This driver software enables a Macintosh to access content on a P2 card inserted
in the P2 drive.
Perform the following steps to install the driver.
1
Insert the supplied CD-ROM.
2
Double-click the “Macintosh” folder on the CD-ROM.
3
For Mac OS X 10.5:
Double click the “Leopard” folder on the CD-ROM.
For Mac OS X 10.6:
Double click the “Snow Leopard” folder on the CD-ROM.
4
Double click the “P2Drive” folder.
5
Double click the “P2DriveFamilyDriver Install.dmg” disk image
module in the “P2Drive” folder.
6
Double click the “P2DriveFamilyDriver Install.pkg”.
7
The driver software installation process will now start. Follow the
instructions given in the installation screen.
◆NOTE:
• If the USB driver is not installed, a sufcient transfer rate may not be obtained.
For the latest information on software drivers, visit the following Web site.
http://pro-av.panasonic.net/
For the latest information on software drivers, visit the following Web site.
http://pro-av.panasonic.net/