Tally lamp
The tally lamp can be illuminated during recording
by setting the TALLY LAMP item of the OTHER
FUNCTIONS screen (Page 62 of Vol.2) to any
setting other than OFF.
The tally lamp will flash in any of the following
circumstances.
Receiving remote control operation •
(flashes 8 times per second)
Recording error has occurred •
(flashes 4 times per second)
Battery is low (flashes 4 times per second)•
Available SD Memory Card capacity is low •
(flashes 4 times per second)
Remaining battery capacity is low •
(flashes once per second)
Remaining memory of the SD Memory Card is •
low (flashes once per second)
Tally lamp
To Next Page
Loading...
