18
Useful Information
Resetting an adaptor
Normally an adaptor does not need to be reset, however, you may need to
reset an adaptor if:
• You are concerned that another adaptor may have been accidentally
registered to your master. (For example, the adaptor of someone who
lives in the same apartment building as you.)
• An error occurs while registering a terminal to the master.
• You are registering an adaptor.
Note
• Resetting a terminal erases its registration to the master. It must be
registered to the master again in order to be used.
• If the master is reset, all terminals must be registered to the master again
in order to be used.
Follow the procedure below to reset an adaptor.
1. With a pointed object press the FACTORY DEFAULT RESET button on
the adaptor for about 3 seconds.
• All the adaptor’s indicators will begin flashing.
2. Once all the adaptor’s indicators stop flashing, the adaptor has been
reset.
• Do not unplug the adaptor for about 30 seconds.
BL-PA300A_OI.book Page 18 Wednesday, August 6, 2008 9:59 AM
To Next Page
Loading...
