For UK
For your safety, please read the following text carefully.
This appliance is supplied with a molded three pin mains plug for your safety and convenience. A 3 ampere
fuse is tted in this plug.
Should the fuse need to be replaced please ensure that the replacement fuse has a rating of 3 ampere and
that it is approved by ASTA or BSI to BS1362.
Check for the ASTA mark
A S A
or the BSI mark on the body of the fuse.
If the plug contains a removable fuse cover you must ensure that it is retted when the fuse is replaced.
If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement
fuse cover can be purchased from your local dealer.
If the tted molded plug is unsuitable for the socket outlet in your home then the fuse should be removed
and the plug cut off and disposed of safely.
There is a danger of severe electrical shock if the cut off plug is inserted into any 13-ampere socket.
How to replace the fuse
The location of the fuse differs according to the type of AC mains plug (gures A and B).
Conrm the AC mains plug tted and follow the instructions below. Illustrations may differ from actual AC
mains plug.
Open the fuse cover with a screwdriver and replace the fuse and close or attach the fuse cover.
Figure A Figure B
Fuse cover
8-E-1
For U.S.A.
Federal Communications Commission Radio Frequency Interference Statement
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursu-
ant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installa-
tion. If this equipment does cause harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
l
Reorient or relocate the receiving antenna.
l
Increase the separation between the equipment and receiver.
l
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
l
Consult the Panasonic Service Center or an experienced radio/TV technician for help.
Warning
To assure continued compliance, use only shielded interface cables when connecting to a computer or pe-
ripheral. Also, any changes or modications not expressly approved by the party responsible for compliance
could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
FCC RF Exposure Warning:
l
This equipment is provided with PC Card slot that could be used with wireless transmitters, which will be
specically recommended when they become available.
Other third-party wireless transmitters have not been RF exposure evaluated for use with this computer
and may not comply with FCC RF exposure requirements.
14
Regulatory Information
To Next Page
Loading...
