EasyManua.ls Logo

Panasonic CQ-C7413U? CQ-C7113U - User Manual

Panasonic CQ-C7413U? CQ-C7113U
38 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
2
Safety Information
CQ-C7413U/C7113U
Warning
Observe the following warnings when using
this unit.
The driver should neither watch the display nor
operate the system while driving.
Watching the display or operating the system will distract
the driver from looking ahead of the vehicle and can cause
accidents. Always stop the vehicle in a safe location and use
the parking brake before watching the display or operating
the system.
Use the proper power supply.
This product is designed for operation with a negative
grounded 12 V DC battery system. Never operate this prod-
uct with other battery systems, especially a 24 V DC battery
system.
Keep batteries and insulation film out of reach of
infants.
Batteries and insulation film can be ingested, so keep them
out of the reach of infants. If an infant ingests a battery or
insulation film, please seek immediate medical attention.
Protect the Deck Mechanism.
Do not insert any foreign objects into the slot of this unit.
Do not disassemble or modify the unit.
Do not disassemble, modify the unit or attempt to repair the
product yourself. If the product needs to be repaired, consult
your dealer or an authorized Panasonic Servicenter.
Do not use the unit when it is out of order.
If the unit is out of order (no power, no sound) or in an
abnormal state (has foreign objects in it, is exposed to
water, is smoking, or smells), turn it off immediately and
consult your dealer.
The remote control unit should not lie about in the
car.
If the remote control unit lies about, it could fall on the floor
while driving, get wedged under the brake pedal, and lead to
a traffic accident.
Refer fuse replacement to qualified service person-
nel.
When the fuse blows out, eliminate the cause and have it
replaced with the fuse prescribed for this unit by a qualified
service engineer. Incorrect replacement of the fuse may lead
to smoke, fire, and damage to the product.
Observe the following warnings when
installing.
Disconnect the lead from the negative (–) battery
terminal before installation.
Wiring and installation with the negative (–) battery terminal
connected may cause electrical shock and injury due to a
short circuit.
Some cars equipped with the electrical safety system have
specific procedures of battery terminal disconnection.
FAILURE TO FOLLOW THE PROCEDURE MAY LEAD TO THE
UNINTENDED ACTIVATION OF THE ELECTRICAL SAFETY
SYSTEM RESULTING IN DAMAGE TO THE VEHICLE AND
PERSONAL INJURY OR DEATH.
Never use safety-related components for installa-
tion, grounding, and other such functions.
Do not use safety-related vehicle components (fuel tank,
brake, suspension, steering wheel, pedals, airbag, etc.) for
wiring or fixing the product or its accessories.
Installing the product on the air bag cover or in a
location where it interferes with airbag operation is
prohibited.
Check for piping, gasoline tank, electric wiring, and
other items before installing the product.
If you need to open a hole in the vehicle chassis to attach or
wire the product, first check where the wire harness, gaso-
line tank, and electric wiring are located. Then open the hole
from outside if possible.
Never install the product in a location where it inter-
feres with your field of vision.
Never have the power cord branched to supply other
equipment with power.
After installation and wiring, you should check the
normal operation of other electrical equipment.
The continuation of their using in abnormal conditions may
cause fire, electrical shock or a traffic accident.
In the case of installation to an airbag-equipping
car, confirm warnings and cautions of the vehicle
manufacturer before installation.
Make sure the leads do not interfere with driving or
getting in and out of the vehicle.
Insulate all exposed wires to prevent short circuit-
ing.
This pictograph intends to alert you to the pres-
ence of important operating instructions and
installation instructions. Failure to heed the
instructions may result in severe injury or death.
Read the operating instructions for the unit and all other com-
ponents of your car audio system carefully before using the
system. They contain instructions about how to use the sys-
tem in a safe and effective manner. Panasonic assumes no
responsibility for any problems resulting from failure to
observe the instructions given in this manual.
This manual uses pictographs to show you how to use the
product safely and to alert you to potential dangers resulting
from improper connections and operations. The meanings of
the pictographs are explained below. It is important that you
fully understand the meanings of the pictographs in order to
use this manual and the system properly.
Warning
This pictograph intends to alert you to the pres-
ence of important operating instructions and
installation instructions. Failure to heed the
instructions may result in injury or material dam-
age.
Caution

Questions and Answers

  • P
    Patricia ClayAug 19, 2025
    What to do if my Panasonic Car Receiver has no power?
    • F
      Frank CookAug 20, 2025
      If your Panasonic Car Receiver has no power, it may be due to a blown fuse. Eliminate the cause of the fuse blowing and replace it with a new one. It is important to determine what caused the fuse to blow in the first place.
  • V
    Vincent HernandezAug 21, 2025
    Why is my Panasonic Car Receiver having poor reception or noise?
    • M
      mark96Aug 22, 2025
      Poor reception or noise in your Panasonic Car Receiver could be due to a faulty antenna installation or wiring of the antenna cable. Check whether the antenna mounting position and its wiring are correct. Also, ensure that the antenna ground is securely connected to the chassis.
  • M
    Michelle AllenAug 25, 2025
    Why is no sound generated from my Panasonic Car Receiver?
    • C
      Clayton SnowAug 25, 2025
      If no sound is being generated from your Panasonic Car Receiver, the wiring of the speaker lines may not be correct, or there might be a break or poor contact. Check the wiring in accordance with the wiring diagram.
  • M
    Matthew HillAug 26, 2025
    Why is there no sound from the speakers of my Panasonic Car Receiver?
    • D
      David ThorntonAug 26, 2025
      If you are getting no sound from the speakers of your Panasonic Car Receiver, there might be a break, a short circuit, poor contact, or wrong wiring in the speaker wiring. Check the speaker wiring to ensure it is correctly connected.
  • T
    Terry CookAug 28, 2025
    Why can't my Panasonic Car Receiver store preset stations?
    • H
      Hannah HaleAug 28, 2025
      If your Panasonic Car Receiver cannot store preset stations, the contact of the battery lead may be poor, or the battery lead may not be always powered. Make sure that the battery lead is securely connected, and then try to preset stations again.
  • J
    Jessica HigginsAug 30, 2025
    How to stop engine noise in my Panasonic Car Receiver?
    • K
      Kathleen GreenAug 30, 2025
      To stop engine noise in step with engine revolutions in your Panasonic Car Receiver, try changing the wiring position of the ground lead. You can also mount a noise filter on the power supply.
  • D
    Daniel PotterSep 1, 2025
    Why is my Panasonic Car Receiver sound skipping or making noise?
    • S
      Sheri WangSep 1, 2025
      If your Panasonic Car Receiver is sound skipping or making noise, there might be a flaw or foreign material on the disc. Remove any foreign material, or use a flawless disc. Playing VBR (Variable Bit Rate) files may also cause sound skipping, so try playing Non-VBR files.
  • J
    Jordan JohnsonSep 3, 2025
    What to do if the speaker channels are reversed on my Panasonic Car Receiver?
    • J
      James ReyesSep 4, 2025
      If the speaker channels are reversed between right and left on your Panasonic Car Receiver, the speaker wiring is likely confused. Perform the speaker wiring in accordance with the wiring diagram.
  • M
    Michael SandersSep 5, 2025
    Why does the sound keep skipping on my Panasonic Car Receiver?
    • M
      Melissa Clark MDSep 5, 2025
      If the sound keeps skipping on your Panasonic Car Receiver, the unit may not be sufficiently secured. Secure the unit to the console box.
  • D
    davidcostaSep 8, 2025
    Why does my Panasonic Car Receiver eject the disc or not play it?
    • T
      Theresa PriceSep 8, 2025
      If your Panasonic Car Receiver ejects the disc or does not play it, ensure the disc is inserted correctly (not upside down). If the disc has unplayable formatted data, refer to the description about MP3/WMA for playable sound data except CD-DA (i.e. music CD).

Summary

Safety Information

Operational Safety Warnings

Lists precautions for using the unit safely while driving.

Installation Safety Warnings

Lists precautions for safely installing the unit in the vehicle.

Safety Information (continued)

Usage Cautions

Lists general safety precautions for operating the unit.

Installation Cautions

Lists general safety precautions for installing the unit.

Customer Services Directory

Limited Warranty

USA Warranty Coverage

Details warranty terms, period, and repair/replacement options for the USA.

Canada Warranty Coverage

Details warranty terms, period, and repair/replacement options for Canada.

Warranty Exclusions and Limitations

Lists conditions and damages not covered by the warranty.

Features

Sound Control Features

Describes sound quality (SQ) and equalizer settings.

Controls Layout

Main Unit Controls Overview

Identifies and describes the main unit's buttons and indicators.

Controls Layout (continued)

Remote Control Buttons

Lists and describes functions of remote control buttons.

General

Power On;Off Operations

How to turn the unit on and off.

Face Plate Removing and Mounting

Instructions for detaching and attaching the face plate.

General (continued)

Source Selection

How to switch between different audio sources.

Volume Adjustment

How to adjust the volume and mute the sound.

Sound Control

SRS WOW Setting

How to adjust SRS WOW 3-D sound technology.

Sound Control (continued)

SQ Adjustment (Sound Quality)

How to adjust equalizer settings for sound quality.

Substitutional Subwoofer (SBC-SW)

How to use the rear speaker as a subwoofer.

Radio

Radio Operation Flow

Steps to tune into radio stations.

Radio (continued)

Station Preset

How to manually preset and select radio stations.

CD Player

CD Operation Flow

Steps to play a CD.

CD Player (continued)

MP3;WMA Player

MP3;WMA Operation Flow

Steps to play MP3/WMA files.

MP3;WMA Player (continued)

Audio Setting

Main Volume and Balance Adjustment

How to adjust main volume, balance, and fader.

Subwoofer and Filter Settings

How to adjust subwoofer levels and filters.

Function Setting

Display Setting

Display Setting (continued)

Customize the Display (Customize Function)

Troubleshooting

No Power or Sound Issues

Solutions for units not powering on or producing sound.

Troubleshooting (continued)

Disc Playback Issues

Solutions for discs not playing or skipping.

MP3;WMA Playback Issues

Solutions for MP3/WMA files not playing or skipping.

Notes on Discs

Specifications

General Specifications

Electrical and physical specifications of the unit.

Panasonic CQ-C7413U? CQ-C7113U Specifications

General IconGeneral
CategoryCar Receiver
TypeCD Receiver
CD PlayerYes
MP3 PlaybackYes
WMA PlaybackYes
Radio TunerAM/FM
Display TypeLCD
Detachable FaceYes
Remote ControlYes
BluetoothNo
USB PortNo
iPod CompatibilityNo
ModelCQ-C7413U
Maximum Power50 Watts x 4 Channels
RMS Power22W x 4
Presets6 AM
Aux InputYes

Related product manuals