Panasonic CQ-DFX983U - Radio; M), Preset Station Setting, FM

E
N
G
L
I
S
H
6
CQ-DFX983/DF903U
21
E
N
G
L
I
S
H
5
CQ-DFX983/DF903U
20
Radio
Band
Press [BAND].
2
Radio Mode
Press [SOURCE] to change to the radio mode.
1
Tuning
[$]: Up
[%]: Down
Press and hold [%] or [$] for more than
0.5 seconds, then release.
Seeking will start.
3
FM1 FM2
FM3AM
Radio mode display
FM stereo indicator
Preset number
Caution:
≥ To ensure safety, never attempt to preset stations while you are driving.
[SOURCE]
[BAND]
(auto preset
memory)
[%] [$]
(tuning)
["] [#]
(preset station)
[1] to [6]
(preset station)
64
97
5
Car Audio
SOURCE
MUTE
POWER
RAND
VOL
312
DISPBAND
REP
6
5
SET
SEL
#
SCAN
MENU
NUMBER
8
0
Note:
≥ When pressing [MENU] in radio mode, the follow-
ing display appears.
This is because radio mode does not have any
menu settings.
Up to 6 stations each can be saved in the FM1, FM2, FM3 and AM preset station memories.
1 Select a band and frequency. (previous
page)
2 Press and hold [1] to [6] for more than
2 seconds to memorize.
Note:
≥ Existing saved stations are overwritten with new stations after this procedure above.
1 Select a band. (previous page)
2 Press ["] or [#].
(Press [1] to [6] on the remote control unit.)
Note:
≥ Frequency setting can be performed even after se-
lecting a preset number.
≥ To cancel preset write, press [DISP] (display).
Manually save a station in the preset memory.
1 Select a band and frequency. (previous page)
2 Press and hold ["] or [#] for more than
2 seconds until the preset number blinks.
3 Press ["] or [#] to select a preset number
(1j6).
4 Press and hold ["] or [#] for more than
2 seconds to memorize.
≥ The display blinks once, and a receiving sta-
tion is saved in the memory.
Automatically save stations with good reception in
the preset memory.
1 Select a band. (previous page)
2 Press and hold [APM] for more than 2 sec-
onds.
≥ The 6 stations with good reception will be auto-
matically saved in the memory under preset num-
ber 1 to 6.
≥ Once set, the preset stations are sequentially
scanned for 5 seconds each. (scanning)
Your favorite radio station can be memorized in [D
•
M] (direct memory).
Default: FM 87.9 MHz
1 Select a band and frequency.
2 Press and hold [D
•
M] for more than 2 seconds.
Frequency blinks once and is saved in the
memory.
Note:
≥ Existing saved station is overwritten with new sta-
tion after this procedure above.
Press [D
•
M].
Press [D
•
M] again to cancel.
Note:
≥ You can recall the direct memory even when the
power is off.
Direct Memory (D
•
M)
∫ Memorize ∫ Recalling the Direct Memory
Manual Preset Memory Auto Preset Memory (APM)
[D
•
M] (direct memory)
["][#] (preset station)
Preset Station Setting
Preset Station Calling