CQ-DX200W
5
English
Wiring
Connecting the speakers
¡ Use ungrounded speakers only.
Allowable input: 50 W or more
Impedance: 4 – 8 Ω
¡ Distance between speaker and amplifier: 30 cm or
more
¡ Do not use a 3-wire type speaker system having a
common earth lead.
Caution
¡ Do not connect more than one speaker to one
set of speaker leads. (except for connecting to
a tweeter)
Before Wiring
Connecting the parking brake connection lead
The parking brake switch position varies with the car
model.
For details on the exact location of the parking brake
switch in your car, contact your dealer.
q Attach a clip connector i to the end of the parking
brake connection lead.
w The clip connector i is connected to the power
source side lead of the parking brake.
Hand brake Foot brake
Parking Brake Lead
(Blue/yellow stripe)
When the parking brake lever is engaged,
the unit is grounded by the chassis.
Parking brake
switch
Car chassis
Battery
Brake light
Clip connector i
Parking brake lead
(Blue/yellow stripe)
Power source side lead
Caution
¡ For safety, be sure to ask your nearest professional installer to do this connection.
When connecting this unit to the rear monitor:
¡ The parking brake lead and grand lead should be connected to the same terminal.
To Next Page
Loading...
