23. GROUP CONTROL
1 Setting group for 1 remote control unit
- When using a remote control thermostat, the thermostat setting is
used for all indoor units in the group.
- During group control, up to a maximum of 16 indoor units can be
connected. (Do not mix heat pump units and cooling only units.)
- Do not mix manual settings and automatic settings. (Manual
settings take priority.)
- The master unit and slave units can all be centrally controlled
during group control. /
Automatic setting for group control
- If the power supplies for indoor units which are connected are
turned on simultaneously, the indoor unit numbers will be
determined automatically after approximately 1 minute. (DIP
switch settings are not necessary.) /
To Next Page
Loading...
