5
PREPARATION BEFORE OPERATION
■ Indoor Unit
1 Open the front panel
2 Remove the air filters
3 Fit the air purifying filters in place
4 Insert the air filters
5 Close the front panel
■ Remote Control
– To set the current time
1 Press 1.
2 Then press 2 to increase or decrease the time.
3 Press 1 again.
Set time at display will light up.
HOW TO OPERATE
■ To start the operation
• Press 1.
• POWER indicator (green) on the indoor unit will light
up.
• To stop, press once more.
■ Setting Mode
• Press 2 to select:
AUTO – Automatic Operation
COOL – Cooling Operation
DRY – Soft Dry Operation
(Dehumidifying Operation)
FAN – Air Circulation Operation
OFF
ON
HEAHEAT
DRDRY
FANANCOOLCOOL
C
H
E
C
K
T
E
M
P
AUTUTO
AU
T
UTO
FA
N
AN
AU
T
UTO
R
E
S
E
T
C
L
O
C
K
A
I
R
S
W
I
N
G
O
F
F
CANCEL
1
2
3
T
IM
E
R
OFF/ON
P
O
W
E
R
F
U
L
E
C
O
N
O
M
Y
SLEEP
O
N
SET
FAN SPEED
MODE
AU
T
UTO
2
3
5
1
6
4
■ Setting Temperature
• Press 3 to increase or decrease the temperature.
• The temperature can be set between 16°C ~ 30°C.
• Recommended temperature:
• During AUTO Operation, press 3 to select:
• Operation with 2°C higher than the standard
temperature.
• Operation with the standard temperature.
• Operation with 2°C lower than the standard
temperature.
● Standard Temperature
• Once the Automatic Operation is selected, the indoor
temperature sensor operates automatically to select
the desired operation mode with Cooling or Soft Dry.
• After the operation mode has been selected, the
mode does not change.
Operation
Cooling
Soft Dry
Standard
temperature
25°C
22°C
Indoor
temperature
23°C
COOL
DRY
26°C ~ 28°C
1°C ~ 2°C
Lower than the
room temperature
CHECK
AUTO
AUTO HEAT DRY FANCOOL
FAN
AUTO
RESET CLOCK
FAN SPEED
AIR SWING
OFF
CANCEL
ON
SET
1
2
3
TIMER
1
2
5
1
3
4
2
To Next Page
Loading...
Need help?
General
