Panasonic CS-C18FFH

4
PRODUCT OVERVIEW
Hints
Troubleshooting
l IndoorfanstopsoccasionallyduringAutomaticFan
Speedsetting.
ä Thisisanadvancedfeaturethathelpstoremovesmellfromthe
surrounding area during operation.
l Ifyouwishtohavethecoolairblowingdirectlyonyou,settheairowdirectiondownwardbutnotforanexcessivelengthoftime,
as it may harm your health.
l Approximately10%ofelectricitycanbesavedifyousetthetemperature1°Chigherthanthedesiredtemperatureduringcooling
operation.
Reset terminals
• Makesureitisnotobstructed.
• Maximumdistances:8m.
• Certainfluorescentlightsmay
interferewithsignaltransmission.
Consultyourdealer.
• Ifthedisplayischaoticorcannot
beadjusted,useascrewdriverto
shortthetwoterminalstoresetthe
remotecontroltotheoriginalsetby
manufacturer.
Remote Control Preparation
n About
Remote Control Signal
• Insertbatteries
 (AAAorR03)
• Thebatteriescanbeusedfor
approximately1year.
• Removethebatteriesifthe
unitisnottobeusedfora
long period.
• Thebatteriesmustbe
recycled or disposed of properly.
Note:
• Theretentionperiodofbatteriesmight
beaffectedtobeshorterbecauseof
the using times of the remote control,
evenlessthanoneyear.
• Pullout
Off/On
Temperaturesetting
Remote Control
Reset the remote control
Transmitter
LCDdisplay
Operationmode
Timersetting
Fan speed selection
F566272_EN.indd 4 2008-12-16 9:59:15