English
13
Cleaning instructions
To ensure optimal performance of the unit,
cleaning has to be carried out at regular
intervals. A dirty unit may cause malfunction.
Please consult authorised dealer.
• Switch off the power supply and unplug before
cleaning.
• Do not touch the aluminium fin, sharp parts may
cause injury.
• Do not use benzine, thinner or scouring powder.
• Use only soap (
pH 7) or neutral household
detergent.
• Do not use water hotter than 40 °C.
Indoor unit
Wipe the unit gently with a soft,
dry cloth.
**Ag Clean
+
Filter & **PM 0.1 filter
• Clean the filter whenever necessary.
• Don’t wash/rinse the filter with water.
• The surface of the filter shouldn’t be rubbed
with any object.
• The filter shouldn’t be pulled with strong force
as it may get damaged.
Ag Clean
+
Filter / PM 0.1 filter.
For seasonal inspection after extended
non-use
• Checking of remote control batteries.
• No obstruction at air inlet and air outlet vents.
• Use Auto OFF/ON button to select COOL
operation. After 15 minutes of operation, it
is normal to have the following temperature
difference between air inlet and air outlet
vents:
COOL: 8 °C
For extended non-use
• Activate nanoe-G operation for 2~3 hours as
an alternative to remove moisture left in the
internal parts thoroughly to prevent mould
growth.
• Turn off the power supply and unplug.
• Remove the remote control batteries.
**nanoe-G Generator
For better efficiency, please clean generator
brush regularly as per below process.
• Turn off main power supply.
• Clean with dry cotton bud.
• Do not touch during operation.
Please remove the Ag Clean
+
Filter / PM0.1 Filter before wash/rinse
the dust filter with water. Ag Clean
+
filter applicable to specific
models only.
Dust filters
Every 2 weeks
• Wash/rinse the dust filters gently
with water to avoid damage to the
filter surface.
• Dry the dust filters thoroughly under shade,
away from fire or direct sunlight.
• Replace any damaged filters.
Remove air filter Attach air filter
Indoor unit
Front panel
Dust filters
**Ag Clean
+
Filter
nanoe-G
Generator
Aluminium fin
**PM 0.1 filters
**PM 2.5 Sensor
• Turn off main power supply.
• Open the Front Panel.
• Peel off the tape on sensor surface (as shown image).
• Clean the lens with cotton swab, after that paste
the tape at same location.
Note : Dirt on the lens may lower sensor sensitivity. Do not scratch the
lens with something hard.Do not use alcohol or cleanser to wipe the dirt.
For better detection of AQI Level, as and when
required you may need to clean sensor lens as
per below process.
To learn more / Cleaning Instructions
Note:
** Applicable for selected models.
To Next Page
Loading...
